• Irene Vanadis

NAIL STAMPING WITH POWDER | Summer nail design using multichrome Flakes

Hello lovely people!

Lou made this bright summer design using the following products:

1. UNT Peel Off Base Coat

2. White nail polish for the base

3. Pretty Serious Polishes from 'Pet Names' collection for the gradient 4. Mitty. Multichrome Flakes. You can use my discount code URBANNAILART for 10% off at Mitty.

5. Stamping plate Pueen Cosmetics 'Lace Blossom'

6. Pueen Cosmetics black stamping polish and latex tape liquid peel off & cuticle guard

7. Water Tight' waterbased smear free topcoat

A must have top coat for when you are working with foils, pigments and it's a great non-smear top coat to apply over your stamping! You can use code (exclusive to my followers!) URBAN10 to get 10% off when you purchase this top coat from www. hitthebottlepolishes.com.au

8. Fast Drying top coat

Basic step by step instructions:

  1. Apply base coat and let it dry completely.

  2. Apply white nail polish for the base.

  3. Prepare your nail polish colours for the gradient. Paint strips on a makeup sponge overlapping nail polish a little bit for better gradient effect. Start dabbing the nail sponge onto your nail, repeat these steps until happy with the opacity.

  4. Apply top coat and let it dry completely.

  5. Apply multichrome flakes over a clear jelly stamper. Remember to use a stamper you don't mind getting cloudy from pigment.

  6. Apply black stamping polish onto the chosen image, swipe any excess polish off of the image with the scraper angled at approximately 45 degrees. Then pick up the image with the stamper prepared in the previous step (with flakes on it). With a rolling motion stamp the image onto your nail. You need to work very fast when doing this step as your stamping polish might dry quick and you won't be able to transfer the image.

  7. Wait a few minutes and then use a fluffy brush to get any excess flakes off of your nails. If you do this step too early, you might smudge your stamped image.

  8. After cleaning up around your nails, apply a waterbased top coat over your stamping and let it dry completely. Non-smear waterbased top coats are great to apply over nail powders (especially holographic ones!) and over stamping in general!

  9. Apply a layer of fast drying top coat.

DISCLOSURE: Some of the codes above are affiliate codes, meaning, at no additional cost to you, I might earn a commission if you make a purchase using my affiliate code.

8 views0 comments